Lectro T1-question for Larry

HI Larry,

I have a lectro T1 transmitter and i have question about its operation
that seems to not be covered in the manual.

The manual reads:

"When the switch is in the XMIT mode, pressing the FREQ up/down
buttons will not disturb the frequency or
the transmitter signal output. In XMIT mode, momentarily pressing the
up FREQ button momentarily dis-
plays the HEX switch settings (shown with an Fr prefix), to the TV
channel, then automatically reverts to the
operating frequency display after 3 seconds unless the button is
held."

The particular unit that i have only displays the frequency not the
hex switch setting. Is this a defect or was feature added to new
units and mine is too old. Software upgradable?

thanks!

john gooch.

Hi John,
The older units, as you guessed, didn't have that feature. Mike
Sepich, the T1 engineer, said later units had more memory and the
feature was added. Service can confirm whether your unit can run the
new firmware. They will need the serial number and possibly the board
version number from inside the unit.
LarryF
Lectro

On 2 May 2007 05:25:45 -0700, johngooch <jgoochmixer DeleteThis @mac.com> wrote:

>HI Larry,
>
>I have a lectro T1 transmitter and i have question about its operation
>that seems to not be covered in the manual.
>
>The manual reads:
>
>"When the switch is in the XMIT mode, pressing the FREQ up/down
>buttons will not disturb the frequency or
>the transmitter signal output. In XMIT mode, momentarily pressing the
>up FREQ button momentarily dis-
>plays the HEX switch settings (shown with an Fr prefix), to the TV
>channel, then automatically reverts to the
>operating frequency display after 3 seconds unless the button is
>held."
>
>The particular unit that i have only displays the frequency not the
>hex switch setting. Is this a defect or was feature added to new
>units and mine is too old. Software upgradable?
>
>thanks!
>
>john gooch.