SMD question for Larry

Hi Jay and Scott,
About 2 to 3 months of the SMd's were made without the +10 mod.
However, all SMq's have the +10 mod. All SM's, SMd's, and SMq's will
be marked with +10 on the blue serial plate with the mod. The SMa's
SMda's and SMqa's (A series) will have the mod but not the marking.
The A's will have both the adjustable low frequency control and the
+10 gain setting as standard along with the Goretex air vent.
Best Regards,
Larry Fisher
Lectrosonics

On 15 May 2007 19:19:08 -0700, Scott Farr <scott RemoveThis @farroutpro.com>
wrote:

>
>Jay Hartigan wrote:
>> Hi Larry,
>>
>> I just purchased an SMD to go with my other 3 SM transmitters. I noticed
>> that the SMD is probably slightly older than the SM units that I bought
>> because they have the +10dm marking next to the serial number while the SMD
>> does not. The SMD is lower level than the SM transmitters and I wonder if
>> you can update the SMD to match the level of the +10 SM's
>>
>> Jay Hartigan
>
>Jay
>
>They will update the SMD, you will have to send it in.
 >> Stay informed about: SMD question for Larry 

So is it possible to bring SMD #237 up to the latest firmware and mods just
like it was new this week? (It is.)
Jay




"Larry Fisher" <lectrosonics RemoveThis @gmail.com> wrote in message
news:gm5m43lailp6klge5no1hv0n2arcg228bu@4ax.com...
> Hi Jay and Scott,
> About 2 to 3 months of the SMd's were made without the +10 mod.
> However, all SMq's have the +10 mod. All SM's, SMd's, and SMq's will
> be marked with +10 on the blue serial plate with the mod. The SMa's
> SMda's and SMqa's (A series) will have the mod but not the marking.
> The A's will have both the adjustable low frequency control and the
> +10 gain setting as standard along with the Goretex air vent.
> Best Regards,
> Larry Fisher
> Lectrosonics
>
> On 15 May 2007 19:19:08 -0700, Scott Farr <scott RemoveThis @farroutpro.com>
> wrote:
>
>>
>>Jay Hartigan wrote:
>>> Hi Larry,
>>>
>>> I just purchased an SMD to go with my other 3 SM transmitters. I
>>> noticed
>>> that the SMD is probably slightly older than the SM units that I bought
>>> because they have the +10dm marking next to the serial number while the
>>> SMD
>>> does not. The SMD is lower level than the SM transmitters and I wonder
>>> if
>>> you can update the SMD to match the level of the +10 SM's
>>>
>>> Jay Hartigan
>>
>>Jay
>>
>>They will update the SMD, you will have to send it in.
 >> Stay informed about: SMD question for Larry 

Hi Jay,
You should already have all the latest SMD firmware. We can do the +10
hardware mod if you need to match to other gear that has it. The
adjustable low frequency is a feature of the SMDa and can't be added
to the SMD since it includes additional parts and a different PC
board.
Best Regards,
Larry Fisher
Lectrosonics

On Thu, 17 May 2007 07:13:26 -0400, "Jay Hartigan"
<jaytakeout RemoveThis @shootersinc.com> wrote:

>So is it possible to bring SMD #237 up to the latest firmware and mods just
>like it was new this week? (It is.)
>Jay
>
 >> Stay informed about: SMD question for Larry