wendt x5 and zaxcom stereo wireless

Hi,

I am having problems with using the wendt x5 and the zaxcom digital
wireless as I am picking up interference- the cable we are using is
becoming an antennae.
We were told to make a change to the cable by firstly coming in at
line level to the zaxcoms and secondly If I remember rightly we fused
two of the pins together on the xlr - regardless the suggested changes
have been made and I'm still experiencing problems.
Any suggestions- is there anything I can do to the mixer to guard it
against this- using the sd 442 I've never had this problem.
thanks
James

I had a lot of problems use the wendt 2 with zaxcom ( checked the wendt 4
and found the same problem), finally found that you have to go unbalance , I
run the minipl stereo mike out to the tx , that's working fine the other
problem until now cant share the same power for both , that's producing
allot of hum



"jamesb" wrote in message

> Hi,
>
> I am having problems with using the wendt x5 and the zaxcom digital
> wireless as I am picking up interference- the cable we are using is
> becoming an antennae.
> We were told to make a change to the cable by firstly coming in at
> line level to the zaxcoms and secondly If I remember rightly we fused
> two of the pins together on the xlr - regardless the suggested changes
> have been made and I'm still experiencing problems.
> Any suggestions- is there anything I can do to the mixer to guard it
> against this- using the sd 442 I've never had this problem.
> thanks
> James